Leaf-Shaped Earrings N6

With spring time just around the corner, these leaf-shaped N6 earrings are ready for you to print and wear, or give away. I’m sure you can find a few good reasons to print them.

Each STL contains symmetric left and right earrings. Each is 30-40mm in diameter and 2mm thick. Those parameters can be tweaked using your slicer. Some styles may be better suited for a 0.25mm or 0.2mm nozzles, but most will print just fine at 0.4mm.

For best results, my advice is to run a bit hotter and a lot slower, but that would be largely dependent on your printer, so use your best judgment.

I hope you enjoy printing them.

Try to 3d print them in the colour that you like. On our store wittystore.com you can find gold, silver or copper 3d filaments, too.